It describes how to prepare for yourĬhapter 3 deals with the online software and all theĭetails of how to actually do your observations. This manual is a reference guide: you do not need to read all of it toĭescribes the telescope and what you need to know before proposing to use it. This manual describes how to apply for observing time, make a scheduleįile, and carry out an observation with the Australia Telescope What is expected during unattended observing.Ĭhanges relating to the rapid response modeĬhanges relating to the RFI surveys at 4cm and 15mmĬhanges relating to the ATCA alarm Twitter feedĬhanges relating to the new 1934-638 high-frequency flux density scaleĪdd a section that can be updated with the latest changes One of the permissions it includes is that very permission to read custom connectors (what did you think is in the Connector table?!).Add a figure to illustrate how to reboot CABB block to chapter 3.įix incorrect description of how to set noise diode periods in the caobs commandĬonsiderable updates to all chapters to clarify some inaccuracies, and to updateīroken links and make HTTPS links by default, and update out-of-date information.Ĭhanges recommended by ATUC, including clarification of NAPA/ToO policies, and of There is an easier solution to the problem: assign Basic User role to the user. There are two Connector tables on the most instances I’ve seen and, just like the USB, you are going to get the first one wrong. Long story short: user was missing read privileges on Connector table (and id mentioned is the id of the entity/table not of the record in the table). The flow uses unspecified list of apps – what is the relevance of this?.What entity/table are we talking about here?.Is that a record with that id or id of the actual entity/table? This information seems to be helpful but then it generates more questions than answers: Shared custom connector with the user (should not need to but just in case)Īnd yet, when the said user tried to run the flow they kept getting this error message.Ensured that the flow runtime permissions are set correctly (correct use of run-only permissions).Shared the flow with the user (should not need to for the solution flows but just in case).Created a manual Power Automate flow as part of the solution.Created, deployed, and configured custom connector into the target environment before importing the solution that uses the connector.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |